Universal Electronics CONTROL 2 Bedienungsanleitung PDF herunterladen (Seite 21)

www.urcsupport.com/atlasocap

RE-ASSIGNING DEVICE KEYS

The Atlas OCAP 5-Device Remote Control can be set up

to control a second device of an already-assigned type.

For example, to have the unit control a TV, a Cable

Converter, and two audio devices (for example, two

audio receivers), re-assign the unused VCR key to

operate the second audio device as follows:

NOTE: VCR is preset at the factory to control an RCA

VCR. Performing the steps below will over-

write those settings.

The VCR key is now ready to be programmed for your

second audio device. See “Programming Device

Control” on page 10. To re-assign other device keys,

repeat these and substitute the key sequence using the

following chart:

NOTE: Only one device can be assigned to an unused

device key at a time.

4. Press and hold SETUP until the CBL key blinks

twice.

1. On the remote control, press VCR once; it will

blink once. Then press and hold SETUP until

the VCR key blinks twice.

2. Enter 9 9 2. The VCR key will blink twice.

3. Press AUD once, then press VCR once. The VCR

key will blink twice.

To Re-Assign Perform Key Sequence

VCR as 2nd

AUD key

VCRÆSETUPÆ9Æ9Æ2ÆAUDÆVCR

VCR as 2nd

TV key

VCRÆSETUPÆ9Æ9Æ2ÆTVÆVCR

VCR as 2nd

CBL key

VCRÆSETUPÆ9Æ9Æ2ÆCBLÆVCR

VCR back to

VCR

VCRÆSETUPÆ9Æ9Æ2ÆVCRÆVCR

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 87 88

Keine Kommentare

Universal Electronics CONTROL 2 Bedienungsanleitung Seite 21